Friday, April 13, 2012

The coder and decoder of green laser pointer is also a piece of cake

Provided the given circuit is correctly connected,  green laser pointer  can be in use without debugging.    The second is the use of safe, its carrying capacity is increased to improve the fragile nature of tempered glass destruction also showed an acute angle of small debris, damage to the human body greatly reduces the tempered glass resistant to thermal shock properties than ordinary glass 2 to 3 times improved, and can withstand temperature changes of more than 150LC had a significant effect to prevent the heat burst. The shortcomings of the tempered glass: Glass in a steel can not be cut and processed, only in the steel before the glass processing to the desired shape, and then processing of steel.
The coder and decoder of  green laser pointer  is also a piece of cake. tempered glass strength is stronger than ordinary glass, but blew tempered glass in the large temperature changes (rupture) the possibility of ordinary glass does not exist blew the possibility. (3) processing equipment One is the ordinary sheet glass or float glass under specific conditions, treatment from the quenching or air quenching processing. Another ordinary sheet glass or float glass by ion exchange method to change the composition of the glass surface, the glass surface to form a laminated stress layer processing from.
This paper introduces the former processing equipment (4) steel furnace principle Has to work principle: the production of good plate glass into the device in the 150s and then after the forced cooling of the cooling section 680 --- 730 degree high temperature heating 100.    green laser pointer  can realize multi-channel remote control.   10s about the thickness of the glass and decided. So tempered glass made of steel furnace manufacturers are mainly distributed in Guangdong, Shandong and Jiangsu, Henan and other places.   (5) steel furnace ceramic roller and the roller on the glass shape.
With the increasingly stringent glass specifications, and especially on the interaction of wave transformation, the new specification, implementation, glass and roller more and more attention. Can cause wavy deformation of the possibility of just a few: glass overheating soften sagging between the rollers; furnace roller uneven surface caused by glass deformation in the furnace; glass heating the relationship between temperature and the roller spacing; and roller eccentricity. The eccentricity of the roller may be caused by insufficient accuracy of the ceramic roller head. The radio frequency technology applied to  green laser pointer  is abbreviated as RF.
The shaft head is loose in the production process, or thermal state beating due to the ceramic quality problems caused by  Roller quasi-direct-TIR Roller TIR (whole run) is very important to the whole run in the hot state, there are strict requirements in order to avoid the glass wave-shaped deformation. The ceramic material must be homogeneous, amorphous. If the ceramic roller structure is uneven, or has too much cristobalite ceramic roller is likely to bend or twist at the working temperature. In fact, radio frequency technology applied to  green laser is radio-frequency current.

No comments:

Post a Comment