The lifetime ofgreen laser pointer will be longer if green laser pointer is used properly

The lifetime ofgreen laser pointer will be longer ifgreen laser pointer is used properly
Of POM Group, Chief Operating Officer (COO) Bhaskar, Dutta, said that for the fine structure of construction performance using expensive materials, laser metal deposition method can reduce the production time, reduce production costs, and compared to traditional machining methods can also reduce energy consumption. Of POM Group is a rapid manufacturing company, the direct metal deposition (DMD) laser technology in a leading position in the industry. Dutta pointed out that in a case study initiated by the U.S. Space Administration (NASA), the establishment of a mirror room, the closed-loop feedback to control the DMD system. The maintenance ofgreen laser pointer still has some requirements.
Case study, the DMD method of manufacturing the parts and electrical discharge machining (EDM) method using a solid metal plate manufactured parts were compared with results show that the EDM method has generated a lot of waste (see Figure 3). "Manufacturing the same parts, and materials processing needs of DMD is only 1/3 of the EDM method required materials, resulting in significant cost savings, especially in terms of expensive materials such as nickel alloys, DMD processing the more obvious advantages. Dutta, said. Figure 3: a case study initiated by the U.S. Space Administration (NASA), the establishment of a mirror room for laser direct metal deposition. The lifetime ofgreen laser pointer will be longer ifgreen laser pointer is used properly.
Case studies on DMD and EDM processing methods were compared, the results show, DMD save materials, reduce energy consumption and improve the processing speed and other aspects are much better than the EDM. Repair and recycling of aircraft manufacturers is expected, they demand the engine will show growth. "2025 is expected to aircraft engines demand more than 114,000 units, which reduce the environmental impact of aircraft engine manufacturers in the manufacturing process, has brought some challenges. Production process of the British Rolls-Royce director Steve Beech said, "for the amount of materials required for some components of the BTF ratio (buy-to-fly ratio, namely the creation of a component and the final parts of the volume of material contained in the ratio. The parameter ofgreen laser pointer has the very accurate requirements.